Menu when controlling: Ronin 4D / Inspire 3
This is in order as you will see it on the Control Deck when connected to a Ronin 4D or Inspire 3
Control Deck remembers it's previous settings when power cycling, or you reconnect to a device type. Example: Going between 4D and Ronin 2, any 4D specific settings will be remembered for when you connect back to it.
Exit Menu
-
You can quickly exit the menu at anytime, by holding MENU/SETUP button (second from right)
Joystick Expo
L / 2 / 3
Twist Axis
On / Off
Enable or Disable the Twist Axis on the Joystick. This is not overridden by Roll Speed OFF
Zoom/Roll Swap
Normal / Swapped
Normal is Zoom on Rocker, Roll on Twist. Swapped is Roll on Rocker, Zoom on Twist
FIZ Control
FIZ / Zoom / Off
FIZ: Control on Control Deck Zoom: Control only zoom (4D), use DJI hand unit for Focus and Iris Off: Hand off all FIZ control to DJI hand unit
Focus Range
Full / Half / Third
Full: maps the full lens focus range to the full range of the focus knob. Half: maps the far half of the lens focus range to the full range of the focus knob. Third: maps the far third of the lens focus range to the full range of the focus knob. Super useful for Inspire 3 focus
Focus Knob Cal.
Calibrate
This calibrates the focus knob on the Control Deck, not the FIZ motors! Turn the Focus Knob to each end gently until it says Complete. You may find it says Complete after just a partial movement, this is because it's tracking the endpoints in the background even when you're not in the menu. It will only calibrate for the full range of the knob.
Roll Speed
Off / L / M / H
Off : Disable roll input on Joystick or Rocker. Roll Trim will ALWAYS remain available! L: Low M: Medium H: High
Shake Mode
1 / 2 / 3
Change the shake algorithm
Shake On Move
On / Off
On: Shake will continue on all axes, regardless of joystick input. Off: Shake will only be on axis that are not getting input from joystick, once input from joystick stops that axis will ease into shake again.
Shake Axis
Axis: P / T / R Shake: On / Off
Enable or disable shake on each axis: Pan / Tilt / Roll
Additional settings on the DJI High-Bright Monitor (HBM)
FIZ Axis Inverts
Invert Zoom Stick On/Off Invert Focus Knob On/Off Invert Iris Slider On/Off
On HBM, go to ... in bottom left then General Settings -> Three-Channel Follow Focus Settings. This allows you to change the direction focus, iris and zoom move relative to the Control Deck's inputs.
EXP Button
Waveform False Color Zebra Stripes
On HBM, go to ... in bottom left then General Settings -> Custom Hand Grips. This allows you to change the exposure tool that shows up on screen when you press EXP on Control Deck.
Unit
Imperial / Metric
On HBM, go to ... in bottom left then General Settings -> Unit Choose Metric or Freedom Units for your lens overlays on screen.
Last updated